Research and development of gas analyzers often requires significant scientific and engineering effort to fine tune the gas ratios going into the system during development of the analyzer. This challenge can be greatly simplified by gas generators and calibration devices which can provide gases in complex mixtures in a broad range of conditions including pressure, concentration, flow rates and over 550 chemicals to simulate the target conditions of the analyzer under development. KIN-TEK can provide a custom
Calibrating Formaldehyde Monitors with Trace Source™ Permeation Tubes Formaldehyde is used in many industries and found in vinyl flooring, pressed wood products, glues, adhesives, pesticides, ceiling tiles, and other materials. Many work environments must monitor for the presence of Formaldehyde to minimize employee long term exposure. Area monitors require regular calibration to validate if air is “GOOD” or “BAD”. Trace Source™ Formaldehyde permeation tubes with a FlexStream™ System will keep you in the “GOOD” zone and
Volatile Organic Compounds (VOCs) are major contributors to pollution and pose a risk to human health. VOCs are regulated by Federal and State agencies and periodic calibration is required to ensure compliance. Benzene, Toluene, Ethyl benzene, and total Xylenes (BTEX) are typically analyzed together as key components to provide an overview of VOC concentrations present in the air. Trace Source™ disposable permeation tubes provide NIST traceable calibration standards for accurate calibration of BTEX gas monitors
KIN-TEK Analytical, Inc. Trace SourceTM Permeation Tubes for Environmental Gas Calibration Regulations related to the analysis of VOC and other common air pollutants, both indoors and out, are increasing. As new analysis and monitoring technologies emerge, the use of sensitive analytical methods require accurate and reliable gas standards for calibration in order to precisely quantify ppb and lower concentrations. KIN-TEK Analytical, Inc. Trace Source™ Permeation Tubes provide precise gas standards for calibration and/or verification
KIN-TEK Analytical, Inc. Span PacTM H2O Gas Standard Generator for Trace Moisture Calibration Trace water contamination affects product quality in a variety of industries. Calibrating analyzers to detect water at sub-ppm, ppb, and pptr concentrations can be challenging. Trace SourceTM water permeation tubes, used within a KIN-TEK Span PacTM H2O system, provide the controls for adding a precise amount of water to the background carrier gas as utilized in the “standard addition” technique of calibrating for trace
The Trace SourceTM Liquid Filled (LFH) Permeation Tube is utilized in KIN-TEK Gas Calibration Systems to generate moderate to high concentration mixtures of low vapor liquids and/or solids such as Water, Benzene, various Sulfur compounds, and Formaldehyde. KIN-TEK provides several types of Trace SourceTM permeation tubes for over 550 chemical compounds including toxic air pollutants, VOCs, acid gases, amines, sulfurs and hydrides. KIN-TEK delivers trace gas calibration product solutions and services worldwide to solve customer
